The non-woven shoe cover machine is economical, practical, energy-saving and environmentally friendly. It does not waste power resources through the exquisite mechanical design, which is in line with the consumption concept of low-carbon and environmental protection of modern users. Many users still have questions about the use process of the non-woven shoe cover machine products. , especially in the installation of shoe covers, today I will take you to learn more about it.
Precautions for the use of non-woven shoe cover machine:
1. When installing the shoe cover, pay attention to the length and width of the shoe cover corresponding to the length and width of the machine. If the length and width directions are reversed, the shoe suit will not be able to fit into the T-shaped bayonet.
2. When there are still shoe covers in the machine, if you want to add shoe covers, you must press the top of the corresponding T-shaped bayonet to push down the new shoe covers, otherwise the hard push may damage the machine.
3. A certain corner of the shoe cover cannot be missed, and the binding wire tied to the shoe cover must be removed in time for each stack of shoe covers installed.
4. When using the shoe cover for the first time, pay attention to check whether the uppermost buckle in the T-shaped bayonet at the four corners of the machine is pulled out by about 1 mm.
5. When using, you should step on the bottom of the machine with a little force at one time. Stepping halfway or too much may affect the timely release of the shoe cover buckle.
6. After the machine has been used for a long time, if the slider does not slide smoothly, you can apply a little lubricating oil in the chute to reduce friction.
7. In order to ensure the accuracy of the set, the time of the shoe set on the machine should not be too long, it is best to use it immediately.
