1. Turn on the air pump switch, connect the air source, pull up the manual air pressure switch on the left side of the console, and raise the pressure roller.
2. Put the compounded finished blanket under the pressing roller, press the manual air pressure switch on the left side of the console, and the pressing roller will descend to press the blanket. Pay attention to keep your hands on the outside of the fabric during operation to avoid crushing your fingers.
3. Set the motorized/manual switch on the console to the manual position, turn on the power, adjust the frequency converter knob on the left side of the console, adjust its value to about 18---20HZ, adjust the frequency converter knob on the right side of the console, and turn it The value is adjusted to about 2.45---2.55HZ. Adjust the light control on the conveyor frame to the corresponding electric blanket size specification.
4. Open the door of the cabinet under the console, there are three-phase and single-phase switches inside, close the switch, and the cloth cutting machine starts to run.
5. Make sure that the flower point of the blanket material is parallel to the pressure roller and the cutter groove. Pay attention to observe the running track of the blanket material. When the flower point moves to the cutting edge on the left side of the cloth cutting groove, quickly turn the manual switch to the motorized position. The cloth cutting machine starts to run automatically.
6. The operator should always pay attention to the size of the cut blanket and the cutting position of the blanket.
